Heat Transfer Vinyl

Twinkle™

Fast Shipping Policy Facts:

  • Done Added as extra charge
  • Done Purolator is our official carrier
  • Done Next day ground service option only (for now)

Description

Wishing for a heat transfer vinyl like no other? Well you can thank your lucky stars because your wish was granted with Twinkle HTV! Twinkle’s silicone-like surface holds brilliant colors that appear to practically shine their own light when the glitter winks and wavers. The intense sparkle gives Twinkle a slight, but significant reflective quality. Every color of twinkle is topped with a mesmerizing glossy glaze that feels fantastic. Whether it’s the lone focus or an incredible accent, Twinkle is your new show stopping heat transfer vinyl!

Twinkle is 225 Microns / 9 Mils and is a PU composition.

Twinkle Applies To:

  • 100% Cotton
  • 100% Polyester
  • Poly/Cotton Blends

Cutter Settings

Cricut Explore Air: Blade: AutoBlade, Standard  Setting: Iron On +
Cricut Maker: Blade: AutoBlade, Fine-Point  Setting: Glitter Iron On
Brother Scan N Cut DX: Blade: AutoBlade  Cut Speed: 5  Half Cut: 4
Silhouette Cameo 4: Blade: AutoBlade, 4  Material: Heat Transfer Glitter  Force: 11  Speed: 8
Roland GX/GS-24: Blade: 45°  Gram Force: 130-160  Offset: .250  Speed: 30-50 cm/s
Graphtec: Blade: 45°  Gram Force: 13  Tool: CBO9U+0  Speed: 30 cm/s
US Cutter Titan 2 & 3: Blade: 45°/60°  Gram Force: 100-110  Speed: 300 mm/s  **Blade Advancing Varies
Mimaki CG-60SR III: Blade: 45° Gram Force: 95  Offset: 30  Speed: 20-30 cm/s
Brother Scan N Cut: Blade: Standard, 3  Cut Speed: 5  Cut Pressure: 5

The specifications listed are suggested starting points that may need to be adjusted according to blade, cutting strip and cutting mat wear. Always perform a test cut prior to cutting designs.

*Craft cutters were evaluated using cutter-specific standard grip cutting mats.

Application Instructions

For Home Iron

  1. Set iron dial between Cotton and Linen
  2. Cover design with Multipurpose Paper or Heat Transfer Cover Sheet
  3. Place on flat, hard surface (ironing board not recommended)
  4. Press iron with medium/firm pressure (do not slide iron)
  5. Press each section of design for 15 seconds
  6. If areas of design lift after application, replace cover sheet and re-press for 10 seconds
  7. Peel carrier warm

For Heat Press

  1. Cover with Heat Transfer Cover Sheet or Multipurpose Paper
  2. Preheat garment for 2-3 seconds
  3. Apply design at 305°F/150°C
  4. Use medium pressure for 15 seconds
  5. If areas of design lift after application, replace cover sheet and re-press for 10 seconds
  6. Peel carrier warm

Care Instructions

  • Wait 24 hours before first wash
  • Machine wash cold with mild detergent
  • Do not bleach or dry clean
  • Dry on low setting

Related products