EasyWeed® Adhesive
Fast Shipping Policy Facts:
- Added as extra charge
- Purolator is our official carrier
- Next day ground service option only (for now)
Description
Compatible with cost-effective screen printing foils and other materials that lend themselves to adhesion, this adhesive is a money saver and a money maker! Even on its own, EasyWeed Adhesive creates a glazed tone on tone appearance that’s trending. The milky colored adhesive features a pressure sensitive carrier and low application temperature that’s gentle enough for almost all heat sensitive fabrics. Cutting EasyWeed Adhesive is like any other EasyWeed product with the shiny, carrier side face down and image mirrored. For best visibility while weeding, we suggest placing the adhesive on a dark surface.
EasyWeed Adhesive is 75 Microns / 2.95 Mils and is a PET Composition.
EasyWeed Adhesive Applies To:
- 100% cotton
- 100% polyester
- Poly/cotton blends
Cutter Settings
Cricut Explore Air: Blade: AutoBlade, Standard Setting: Vinyl +
Cricut Maker: Blade: AutoBlade, Fine-Point Setting: Heat Transfer (Non-Cricut)
Brother Scan N Cut DX: Blade: AutoBlade Cut Speed: 5 Half Cut: Auto
Silhouette Cameo 4: Blade: AutoBlade, 3 Material: Heat Transfer, Smooth Force: 5-6 Speed: 8
Roland GX/GS-24: Blade: 45° Gram Force: 70-90 Offset: .250 Speed: 30-50 cm/s
Graphtec: Blade: 45° Gram Force: 7-9 Tool: CBO9U+0 Speed: 30 cm/s
US Cutter Titan 2 & 3: Blade: 45°/60° Gram Force: 80-85 Speed: 300 mm/s **Blade Advancing Varies
Mimaki CG-60SR III: Blade: 45° Gram Force: 80 Offset: 30 Speed: 20-30 cm/s
Brother Scan N Cut: Blade: Standard, 2 Cut Speed: 5 Cut Pressure: 1
The specifications listed are suggested starting points that may need to be adjusted according to blade, cutting strip and cutting mat wear. Always perform a test cut prior to cutting designs.
*Craft cutters were evaluated using cutter-specific standard grip cutting mats.
Application Instructions
For Home Iron
- Set iron dial between Cotton and Linen
- Cover design with Multipurpose Paper or Heat Transfer Cover Sheet
- Place on flat, hard surface (ironing board not recommended)
- Press iron with medium/firm pressure (do not slide iron)
- Press each section of design for 10-15 seconds
- If areas of design lift after application, replace cover sheet
and re-press for 5-10 seconds - Peel carrier hot
For Heat Press
- Cover design with Multipurpose Paper or Heat Transfer Cover Sheet
- Preheat garment for 2-3 seconds
- Apply design at 275°F/135°C
- Use medium pressure for 5-10 seconds
- Peel carrier hot
Care Instructions
- Wait 24 hours before first wash
- Machine wash warm or cold with mild detergent
- Do not bleach or dry clean
- Dry on normal setting
- Liquid fabric softener not recommended